Banner Images

TIP...
of the Iceberg

Know where your main water shutoff is located

Make a point of locating your main water shutoff, ensure it is well labelled and advise everyone…

Our PROJECTS

Residential Domestic / Hydronic Water Installation

Uponor Controls and Poly pipe cladding on boiler copper lines

Residential Domestic / Hydronic Water Installation

Frequently Asked QUESTIONS

FAQ

Can I add different makes of chimney to my existing chimney system?

No, chimney components from different manufacturers cannot be combined. Code dictates that a chimney system must be comprised of components as certified by one manufacturer. Futhermore, most components are designed in such a way as not to fit correctly if matched with another system's components,  rendering it not only uncertified but extremely unsafe.

read details

Gas Detection

Gas detectors should be maintained and calibrated, in some cases, annually. NCH can calibrate most gas detectors onsite. Gas calibrations are performed using certified calibration gases and according to specific manufacturers procedures and specifications. Often most sensors can have life spans up to 5 years, but most should be calibrated annually. Our calibration services start at $150 per sensor not including travel or special expenses (if required). Calibrations come with a certificate of calibration which is often a requirement of OH&S or company Safety policies. Any sensors which fail calibration can be replaced or repaired by NCH technicians.